ASB series

Inquire product

The ‘Duaclave’ is the ideal autoclave where laboratory space is at a premium. The Duaclave features two identical chambers, stacked one directly above the other, giving double the capacity for the same footprint. Combining two units within one frame, the two chambers operate completely independently – for example, allowing you to run a glassware cycle in one chamber whilst preparing your media with the other. Duaclave models are only available with ‘heaters in chamber’.

Features
  • A choice of 33, 43 and 63 litre models
  • Base Shelf in each chamber
  • Calibration and Validation available
  • FDA 21 CFR part 11 software option available
  • Cooling Lock
  • Fast action door closure mechanism
  • Five password levels to stop lower level users making changes
  • Five pre-programmed cycles and up to 50 available
  • Holdwarm / Delayed Start feature
  • Optimised for low water and power consumption
  • Over Temperature Protection
  • Pressure Gauge
  • Standard Astell safety features
  • Temperature range of 100°C to 138°C (0.2 - 2.4 Bar)
  • Timed/Pulsed Free Steaming
  • Fully programmable 5.7" Colour Touch Screen controller
  • Validation Port
Additional options
  • Load Sensed Process Timing
  • Pulsar Freesteaming
  • Integral data printer
  • FDA 21 CFR part 11 controller software
  • Remote maintenance/diagnosis
  • Ethernet interface
  • IQ/OQ documentation
  • Assisted air cooling
  • Advanced water cooling
  • Autodrain
  • Autofill
  • Drain Cooling
  • Category III (BSL-3) compliance
  • Morrison discard container (W:280 x H:290 x D:330mm)
  • Container tray (W:279 x H:127 x D:279mm)
  • Additional shelf kit (for ASB260/ASB270)
  • Water softener (compact)
  • Direct Steam model
Installation requirements

Power requirements: The power requirements for the standard machines are listed in the Specifications table, however these can vary depending on the options selected. For details on the exact power requirements on these options please contact us. N.B. A Neutral line and protective Earth are required for all electrically heated units.

ASB model water and drainage requirements: A cold water supply of 2-6 Bar minimum, 4 litres/min is required for the ‘Autofill’ option. Max temperature 25°C, Max flow rate 20 litres/min. Requirements vary for RO/de ionised/hard water

Drainage: Free venting, non-manifolded drain (35mm diameter) capable of withstanding temperatures up to 100°C.

Download

Let's get to know each other

Would you like to purchase one of our products, do you have any question about a product or about services or do you need further information?

We are always just one phone call away or you can send us a message here